Prepare and install the new wall sleeve according to the instructions below.
Ptac wall sleeve installation instructions.
All wall and window wall installations must provide for proper drainage.
For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames.
Consult a licensed contractor as needed.
Inches mm inches mm inches mm wall sleeve only 3 75 0 0 0 0 subbase kit 3 75 3 1 4 85 2 3 4 70.
Tools required by.
Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve chassis and accessories.
While the dimensions may appear to be incompatible the 2 devices should fit properly.
If the sleeve projects more than 8 into the room a sub base or other means of support must be used.
Wall case must be sealed caulked to outside wall on all four 4 sides.
To ensure proper airflow and filter removal it is recom mended installation of the wall sleeve be a minimum of 36 from the ceiling.
16 24 28 and 31 deep cases are available for thicker walls.
Installation guidelines for sealing ptac sleeves read these instructions completely before starting any installation.
The wall sleeve must be fastened securely before installing the air conditioner unit.
For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames.
For new installs ensure the wall is properly framed to support the weight and dimensions of the wall sleeve and air conditioner.
When you visit any website it may store or retrieve information on your browser mostly in the form of cookies.
See the drain kit for internal actual installation instructions.
Wall sleeve installation 920 087 04 8 05 wall sleeve installation instructions pdxws note.
This information might be about you your preferences or your device and is mostly used to make the site work as you expect it to.
Wall case should be sealed caulked to the inside wall on all four 4 sides.
In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.
Failure to install and maintain our product according to these instructions may void any product warranty.
Page 3 pre installation considerations before proceeding with the sleeve installation ensure the following guidelines for locating the wall opening and sleeve are met.
In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.
There is a portion of the air conditioner which extends a few inches back into the room.
Standard steel wall cases are 42 w 16 h 13 3 4 d.
The sleeve will fit flush in the wall extending outside the structure.
Figure 4 minimum interior and exterior note.
The air conditioner will slide into the sleeve but is not flush with the wall.
